Thanks for your reply.
I had uploaded marlin from 3 different sources and tried to heat the bed. Every time there is 0V on Sanguinololu pins.
When i plug the heatbed to the extruder connector it get hot in just seconds.
I have tried to heat the bed in Pronterface and Yarrh.
The wiring is not the case, becouse i check the voltage on Sanguinololu pins.
The Termistors are 100k EPCOS and that's the type which i set in Marlin.
What about pin-layout? Can you tell something more about it?
I had uploaded marlin from 3 different sources and tried to heat the bed. Every time there is 0V on Sanguinololu pins.
When i plug the heatbed to the extruder connector it get hot in just seconds.
I have tried to heat the bed in Pronterface and Yarrh.
The wiring is not the case, becouse i check the voltage on Sanguinololu pins.
The Termistors are 100k EPCOS and that's the type which i set in Marlin.
What about pin-layout? Can you tell something more about it?
