Agin thanks for Your reply.
The pins are set right in Marlin.
The temperature shown in pronterface is the same as room temp (T.25.0)
Now i would like to apologize for my lame... but in not good in electronic stuff. So i tried to check mosfet by simple voltmeter.
I put one end of voltmeter to the "Drain(Flange)" as show on picture attached to this post and other end to the "Gate".
On Hotend mosfet measured by this way - there is 5V.
On Heatbed mosfet measured by this way - there is 0-0,3V.
Did i checked mosfets right? Does it mean, that the heatbed mosfet is blown?
The pins are set right in Marlin.
The temperature shown in pronterface is the same as room temp (T.25.0)
Now i would like to apologize for my lame... but in not good in electronic stuff. So i tried to check mosfet by simple voltmeter.
I put one end of voltmeter to the "Drain(Flange)" as show on picture attached to this post and other end to the "Gate".
On Hotend mosfet measured by this way - there is 5V.
On Heatbed mosfet measured by this way - there is 0-0,3V.
Did i checked mosfets right? Does it mean, that the heatbed mosfet is blown?