Hi Everyone,
I have a prusa mendel reprap. All of the parts are fully assembled and ready to go. I gave up a while back trying to install the software etc to make it run. (the furthest I got was getting all axis to move in whichever direction i desired). I never managed to get the extruder extruding but I think I know why that was.
My question is:
I am currently in invercargill and would like to get my printer going again. I think I need someone who already has a fully functioning 3d printer to assist me in getting it running.
Firstly: Is there anyone in the area (I am willing to travel as far as queenstown/dunedin.) that has a working reprap?
Secondly: Are they willing to help me out? Perhaps hooking up their reprap electronics to mine to see if it is my electronics that were causing me issues.
I have a sanguinololu board.
Any questions please ask. Any help most appreciated as I have had the reprap built for over a year now and still have not got it to build a part. I am very determined now.
I have a prusa mendel reprap. All of the parts are fully assembled and ready to go. I gave up a while back trying to install the software etc to make it run. (the furthest I got was getting all axis to move in whichever direction i desired). I never managed to get the extruder extruding but I think I know why that was.
My question is:
I am currently in invercargill and would like to get my printer going again. I think I need someone who already has a fully functioning 3d printer to assist me in getting it running.
Firstly: Is there anyone in the area (I am willing to travel as far as queenstown/dunedin.) that has a working reprap?
Secondly: Are they willing to help me out? Perhaps hooking up their reprap electronics to mine to see if it is my electronics that were causing me issues.
I have a sanguinololu board.
Any questions please ask. Any help most appreciated as I have had the reprap built for over a year now and still have not got it to build a part. I am very determined now.