Hey,
The resistence of my Heatbed is 0.6 Ohm (the wiki says 0.8 [http://reprap.org/wiki/PCB_Heatbed#Electronics] i think thats ok).
My Power Supply supports up to 36 Amperes on the 12V line, i think thats also enough!
I read that a few of the Power supplys needs a base load, so i connected a DVD Drive and a Hard Drive but i get the same result, when i turn my heatbed on the power supply shuts down! I have the CP4-520-v2.0 from Speed Link (http://www.speedlink.com/?p=2&cat=2I2&pid=23642&paus=1)
:(
The resistence of my Heatbed is 0.6 Ohm (the wiki says 0.8 [http://reprap.org/wiki/PCB_Heatbed#Electronics] i think thats ok).
My Power Supply supports up to 36 Amperes on the 12V line, i think thats also enough!
I read that a few of the Power supplys needs a base load, so i connected a DVD Drive and a Hard Drive but i get the same result, when i turn my heatbed on the power supply shuts down! I have the CP4-520-v2.0 from Speed Link (http://www.speedlink.com/?p=2&cat=2I2&pid=23642&paus=1)
:(