Hello Guys! i think I have a problem with a short circuit somewhere on my board I think. I am new to this technology and am not quite sure what went wrong.I connected it once and managed to make it move but then I rearranged something on the structure of the printer. I was trying to connect my power supply to the sanguinololu again afterwards, but it wouldn't work. I ve tested the power supply, it works fine, which means there must be something wrong somewhere on the board. Do you have an idea about how to find out? Is it possible to fix or do I have to buy a new one? How can I find out what went wrong?
Thank you!
Zuzu.
Thank you!
Zuzu.