Something else interesting I noticed is that when I hit the reset button on the Sanguinololu, the X, Y and Extruder motors "freeze" and make a bit of a humming noise for a few seconds. After the reset they stop buzzing and are free to move by hand again.
I also tried unplugging the limit switches and heaters and it still wouldn't connect. I then unplugged all the stepper motors and it still made no difference. Now the only things plugged in are the power and USB (and the stepper motor drivers).
Any ideas?
I also tried unplugging the limit switches and heaters and it still wouldn't connect. I then unplugged all the stepper motors and it still made no difference. Now the only things plugged in are the power and USB (and the stepper motor drivers).
Any ideas?