I'm working through calibration of my huxley from the reprap wiki:
[reprap.org]
I'm at the part which sets the steps per mm for extrusion. The wiki says the current value can be checked with the GCode command M503. I asked on the IRC about this as this command does nothing on my machine. I was told that the EEPROM is probably not enabled in the firmware of the sanguinololu. It took me a while to even work out how to find out what firmware was in my device. I eventually found the GCode command for this and found out that I'd got Sprinter firmware installed. My next step was to clone the Sprinter git repo to look at the code to see what the command was to enable the EEPROM but can't find any switch in the build env or any reference to a GCode command.
Can anybody tell me how you enable the EEPROM in the Sprinter firmware.
In addition I've got arduino_1.0.5 installed and the Sprinter won't build as it has problems with this version of Arduino. Can anybody tell me where the best place is to get info on the Sprinter firmware?
[reprap.org]
I'm at the part which sets the steps per mm for extrusion. The wiki says the current value can be checked with the GCode command M503. I asked on the IRC about this as this command does nothing on my machine. I was told that the EEPROM is probably not enabled in the firmware of the sanguinololu. It took me a while to even work out how to find out what firmware was in my device. I eventually found the GCode command for this and found out that I'd got Sprinter firmware installed. My next step was to clone the Sprinter git repo to look at the code to see what the command was to enable the EEPROM but can't find any switch in the build env or any reference to a GCode command.
Can anybody tell me how you enable the EEPROM in the Sprinter firmware.
In addition I've got arduino_1.0.5 installed and the Sprinter won't build as it has problems with this version of Arduino. Can anybody tell me where the best place is to get info on the Sprinter firmware?