I dont think the make file is very well maintined... looks like its hardcoded for 022 (more than just the path)
Use the arduino GUI and load the Sprinter.pde file. then just hit the verify icon.
If that works then you have to make sure that endstops and thermisters match your hardware in configuration.h
Just about everything else is then editable in eeprom settings later.
Use the arduino GUI and load the Sprinter.pde file. then just hit the verify icon.
If that works then you have to make sure that endstops and thermisters match your hardware in configuration.h
Just about everything else is then editable in eeprom settings later.