Endstops work. M119 reports them correctly.
As X and Y axels don't move and Z moves always down I don't have any working axel. I haven't tested E yet as I would require to me to heat up the extruder but I'm trying that next. Anyway I swapped some of the stepsticks and now Y doesn't move and X moves always towards the endstop (to left). I didn't test Z as it almost crashes to the heatbed (only a few millimeters space to move down).
Edit: E also moves only one direction (it doesn't matter if I extrude or reverse). Also the Y axis moves only one way when I swapped X and Y axis stepsticks (and X doesn't move anymore, which is not surprising). I guess I should check if DIR pin is tied to GND or VCC.
As X and Y axels don't move and Z moves always down I don't have any working axel. I haven't tested E yet as I would require to me to heat up the extruder but I'm trying that next. Anyway I swapped some of the stepsticks and now Y doesn't move and X moves always towards the endstop (to left). I didn't test Z as it almost crashes to the heatbed (only a few millimeters space to move down).
Edit: E also moves only one direction (it doesn't matter if I extrude or reverse). Also the Y axis moves only one way when I swapped X and Y axis stepsticks (and X doesn't move anymore, which is not surprising). I guess I should check if DIR pin is tied to GND or VCC.