I did a bunch of searches last night but I tried a different one this morning and found something else good to try (and a link to another doc):
From this post: [forums.reprap.org]
It references this other post which had the solution: [forums.reprap.org]
I'll try this out tonight and see if I can get things going. Then I'll start working on trying upgrade to the latest Marlin.
BTW, is there any point in "updating" the boot loader? Assuming there is one installed already, are there any improvements worth upgrading or if it works don't worry about it?
Quote
PandPP
As per [forums.reprap.org], I needed to change the baud rate down to 38400, but also the protocol from stk500 to arduino.
Windows had defaulted the port speed to 57600 in Device Manager, so that needed dropping down to 38400 as well.
Hey presto, it works.
From this post: [forums.reprap.org]
It references this other post which had the solution: [forums.reprap.org]
I'll try this out tonight and see if I can get things going. Then I'll start working on trying upgrade to the latest Marlin.
BTW, is there any point in "updating" the boot loader? Assuming there is one installed already, are there any improvements worth upgrading or if it works don't worry about it?