Welp, I'm not out of the woods just yet.
The reason I have not given any feedback here is that I was waiting for my adapter to arrive. I gave up on trying to make my own and ordered one off ebay. So today it arrived and I immediately hooked it up. And lo and behold.... nothing changed. I'm still getting either a blank blue screen or the background grid, depending on which way I connect the EXP1<->EXP2
Also, going on a hunch I tried Marlin 1.0.2 (Been using the Dev release) and I immediately got the same compile errors sarf2k4 was talking about.
I tried initializing the SD card in Octoprint to see if it could just be a backlight thing, but that fails as well.
I'm at a loss here. If I was not seeing this error pop up for others out there, I'd figure I have a faulty LCD
The reason I have not given any feedback here is that I was waiting for my adapter to arrive. I gave up on trying to make my own and ordered one off ebay. So today it arrived and I immediately hooked it up. And lo and behold.... nothing changed. I'm still getting either a blank blue screen or the background grid, depending on which way I connect the EXP1<->EXP2
Also, going on a hunch I tried Marlin 1.0.2 (Been using the Dev release) and I immediately got the same compile errors sarf2k4 was talking about.
I tried initializing the SD card in Octoprint to see if it could just be a backlight thing, but that fails as well.
I'm at a loss here. If I was not seeing this error pop up for others out there, I'd figure I have a faulty LCD