OI !!! just days and days of headaches here.
Ok, I had the 10pin to 6 pin cable that came with it still in my drawer so all good there. Plugged in the power supply to the Sanguinololu board and the ISP header into the USBISP set the Arduino IDE to use USBISP and selected upload by programer (CTRL+SHIFT+U)- no luck, here is the error.
Arduino: 1.6.13 (Windows 10), Board: "Sanguino, ATmega1284 or ATmega1284P (16 MHz)"
Sketch uses 51,132 bytes (39%) of program storage space. Maximum is 130,048 bytes.
Global variables use 2,694 bytes (16%) of dynamic memory, leaving 13,690 bytes for local variables. Maximum is 16,384 bytes.
avrdude: warning: cannot set sck period. please check for usbasp firmware update.
avrdude: error: program enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
the selected serial port
does not exist or your board is not connected
This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.
Ok, I had the 10pin to 6 pin cable that came with it still in my drawer so all good there. Plugged in the power supply to the Sanguinololu board and the ISP header into the USBISP set the Arduino IDE to use USBISP and selected upload by programer (CTRL+SHIFT+U)- no luck, here is the error.
Arduino: 1.6.13 (Windows 10), Board: "Sanguino, ATmega1284 or ATmega1284P (16 MHz)"
Sketch uses 51,132 bytes (39%) of program storage space. Maximum is 130,048 bytes.
Global variables use 2,694 bytes (16%) of dynamic memory, leaving 13,690 bytes for local variables. Maximum is 16,384 bytes.
avrdude: warning: cannot set sck period. please check for usbasp firmware update.
avrdude: error: program enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
the selected serial port
does not exist or your board is not connected
This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.