Just wanted to say thanx Dust, I have things going well enough to work with it all at this point. I found some indications online that an aruidno board can in some situations work without a bootloader. I am starting to think that either the bootloader on it is missing the USB components OR is just not there at all...
So I am going to do as you suggested in one of your posts and use the M92 commands and save to EEPROM for now to do all the calibration and then take all those settings and put them in configuration.h to do a final flash over the ISP header to finalize it all.
Then having chocked all this up to a great bit of learning I am going to get a Ramps4 board in a few weeks and put the Sanguinololu in the drawer.......
:) Thank you very much for your help :)
So I am going to do as you suggested in one of your posts and use the M92 commands and save to EEPROM for now to do all the calibration and then take all those settings and put them in configuration.h to do a final flash over the ISP header to finalize it all.
Then having chocked all this up to a great bit of learning I am going to get a Ramps4 board in a few weeks and put the Sanguinololu in the drawer.......
:) Thank you very much for your help :)