Thanks again.
So my plan would than be the following:
The chip is the one from the Gen6 electronics, as far as I understood the corresponding RepRap Wiki. And I want to be using the the 1284 settings of the sanguino in Arduion although it sais 1048 on the chip, right? Or just see what works best?
So my plan would than be the following:
- Back up the running firmware like described here: [reprap.org]
- Use the M501 command to get most of the settings
- Donwload Marlin 1.1.8 and adapt it to my printer (incl. the fan support)
- Enabel additional features carefully, if at all
- See if it works (if not, re-install image of running firmware)
The chip is the one from the Gen6 electronics, as far as I understood the corresponding RepRap Wiki. And I want to be using the the 1284 settings of the sanguino in Arduion although it sais 1048 on the chip, right? Or just see what works best?