Today I completed a Marlin 1.1.9 version with all the settings for my Orca. I set the Arduino to Sanguino and the processor to ATmega644P 16Hz. Done so, the compiling runs without errors. Before I send it through Arduino I made sure that I can upload the old backup-hex file and it worked like a charm. Sending it to the gen 6 deluxe board produce an error.
avrdude: stk500_recv(): programmer not ready
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x03
After I got this from Arduino I d´tried the command line way that had worked before for my backup. Now the command line also produces the same error. Is somehow the fuse set wrong? I guess something is wrong with the boot loader. Any ideas?6.3
Reading is still possible with Avrdude V 6.3.
It closes with safe mode: Fuses O.K. (E:00, H:00, L:00)
avrdude: stk500_recv(): programmer not ready
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x03
After I got this from Arduino I d´tried the command line way that had worked before for my backup. Now the command line also produces the same error. Is somehow the fuse set wrong? I guess something is wrong with the boot loader. Any ideas?6.3
Reading is still possible with Avrdude V 6.3.
It closes with safe mode: Fuses O.K. (E:00, H:00, L:00)