Re: Endstops acting odd :S

Well, maybe that idea isn't working so well... I'm starting to think that my motherboard has a short somewhere, because no matter what I do, whether I switch it to a known good switch and cable, it does the same thing.... so at this point I'm stumped.

As for the Wiki, it seems to be good, but the section that gave me the Idea was the electromagnetic noise part. What I essentialy did, was create a shielded cable by wrapping it with aluminum tape. The Idea seemed to work, but after one or two sucessfull prints, The same thing happened, which is making me think that my motherboard has a short.

So I guess, my next question would be relating to the Sang board and the Marlin firmware.

At least until I have some more Cash on hand to get a new board, I need to keep this printer working. So in the meantime, I would like to map the sensor input to a different set of pins on the sanguinololu. What I need to know, is what pins do I set them to in the pins.h section of the marlin firmware? Is this possible? (if possible, what I would like to do is swap it with the bed temp pins, because I don't have a heated bed, and am currently limited to PLA)

Thanks